MMM-PIR-Sensor - White Screen

[Bangee]

If you use pin 7 in your config its nr 4

You have to use the gpio nr.

[samydp]

Thank you it works fine !!

[phantomlight]

@Bangee I tried everything regarding the white screen issues. I’m a noob. was able to get magic mirror installed, I also installed the PIR motion detection and can confirm motion is detected.

Downgraded Node JS
Installed the electron
made sure module was added in config.js

I am using the Raspberry PI 3 mode b.

Can somebody confirm this module is working with Raspberry Pi 3.

Any help would be greatly appreciative…
Thanks.

[Bangee]

can you restart the magicmirror an check what errormessage you have:
pm2 logs mm

[phantomlight]

@Bangee Thank you so much for responding. I removed magic mirror completely reinstalled… then installed the module.

All is well now… Thank you so much!

[bibi]

@Bangee hi ! thx for your nice tuto, i have proceed with it but i got a warning as below:

pi@raspberrypi:~/MagicMirror/modules/MMM-PIR-Sensor $ npm install
npm WARN prefer global npm@3.10.9 should be installed with –g
do i have to do smt specific or it’s just ok to leave it without any action?
ps: my config file is also not working with PIR module implemented… maybe that is the reason? thx you very much for any feedabck guys!!

[Bangee]

@bibi did you try it with the instructions from paviro:
https://github.com/paviro/MMM-PIR-Sensor

I don’t think that this warn is your problem. I have so many times these warnings :-D
You sould send us whats in your pm2 logs mm

[bibi]

@Bangee yes i follow his and yours… quite the same… regarding this npm warning I do nothing then as understood?
I will send you the log later when I’m home
Thx bangee! Appreciated!

[bibi]

@Bangee so as expected the pm2 log mm just show that the file has syntax error… here is my config file, i put the module at the end…

thx again :)

[strawberry 3.141]

@bibi powerSaving: true