[octomirror-module] Monitor & Control an OctoPrint 3D Printer Server

shbatm

Can you please post your config section? Have you enabled the API and provided an API key?

michael24h

@shbatm said in [octomirror-module] Monitor & Control an OctoPrint 3D Printer Server:
please post your config section

citizendevpi

}, {
        module: "octomirror-module",
        position: "bottom_left",
        config: {
            url: "http://192.168.2.141",
            api_key: "B7ACF3C4BDD04D61BF5176C75778661E",
        }
    },

so i obviously cannot figure out how to copy paste my config i feel like i have some issues

citizendevpi

@shbatm yes I have enabled the API as you can c it is in my config

shbatm

@citizendevpi Try adding debugMode: true, to the config and see if you get any useful information in the logs. I can’t remember if they’ll show up in the console or DevTools. Also, it’s been a while since I’ve used the module, but it will only show data when it’s actually printing too.

michael24h

@citizendevpi said in [octomirror-module] Monitor & Control an OctoPrint 3D Printer Server:

url: “http://192.168.2.141”
Looks like link isn’t complete. Should looks like this http://ip_address/webcam/?action=stream

{
        module: 'MMM-MotionEye',
        position: 'top_right',
            config:  {
            width: "460px",
            autoHide: false,
            url: "http://octoprint IP address/webcam/?action=stream",
            debug: false,    
            user: "pi"  
        }
    },

I hope this will help you

michael24h

Try open octoprint > go to webcam > then open image in new tab. and copy http address from web browser to your config file in octomirror-module.

shbatm

@michael24h said in [octomirror-module] Monitor & Control an OctoPrint 3D Printer Server:

Looks like link isn’t complete. Should looks like this http://ip_address/webcam/?action=stream

Nope, that shouldn’t be it. He said his stream was working and the url parameter is just for the octopi instance, not the stream. The module assumes it needs to add /webcam/?action=stream” unless streamUrl is provided.

shbatm

@citizendevpi

Just confirming: you are using my version https://github.com/shbatm/octomirror-module not the original, correct?

citizendevpi

@shbatm let me check and yes u are correct I do have my stream no problem but no info and I would only expect it to give me stats when printing