pi3b+
24" Dell monitor
key hook hardware

@teegray1124 it is hung with a french cleat.

@sdetweil Should I start with the current Pi OS on the SD card and then begin those scripts?

What is the best way to reliably run MagicMirror on a pi Zero W? I have found some articles and how-to’s but they are all outdated. Most reference using older versions of Raspbian. Thanks for any help.

I figured this out.

the new router uses a different IP structure. 192.168.0.1 where my old router used 192.168.1.1. For some reason the pi connected to the new router but saved the old default gateway. I was able to correct it with the below command.

sudo route add default gw 192.168.0.1 dev wlan0

Actually it looks like it’s not connecting to the internet even though it’s connected to the router. I can’t get to the internet at all.

I got a new router. I connected to the router’s WiFi network in the pi’s OS and rebooted, none of the modules will load. Any help is much appreciated.

@teegray1124 it is hung with a french cleat.

pi3b+
24" Dell monitor
key hook hardware

Not sure. I am new to all this, but that is what I did and it works now. Thanks for the help.

I think I fixed this. There was a file called mm.sh in the home directory, I moved it to the trash and I only see one instance now. I’m guessing there is something already starting Magic Mirror someplace else?

They are both labeled MagicMIrror2 and they both will automatically re-start if I quit them with CTRL+Q.