Posts made by hedmik

@sdetweil my code looks like this, perhaps it’s a need for an update…?

@snille Hi, trying to use this module but getting below error.
I followed your instructions i hope :-)
[07.01.2022 17:10.13.062] [ERROR] (node:30547) UnhandledPromiseRejectionWarning: TypeError: Cannot read properties of undefined (reading ‘body’)
at /home/pi/MagicMirror/modules/MMM-homeassistant-sensors/node_helper.js:40:83
at runMicrotasks ()
at processTicksAndRejections (node:internal/process/task_queues:96:5)
[07.01.2022 17:10.13.067] [ERROR] (node:30547) UnhandledPromiseRejectionWarning: Unhandled promise rejection. This error originated either by throwing inside of an async function without a catch block, or by rejecting a promise which was not handled with .catch(). To terminate the node process on unhandled promise rejection, use the CLI flag --unhandled-rejections=strict (see https://nodejs.org/api/cli.html#cli_unhandled_rejections_mode). (rejection id: 46)

Wow, thanks for sharing this!!!
Now, I’m back on track again :-)

Hi,

I’m using mmm-hue-lights and want to display temperature and/or the last motion from a Philips Hue motion sensor (indoor and outdoor).
Anyone added that feature…?

/Mikael

@jorgnyg i’ve tried to upload again but still not working :-(

@devmil Hi Michael, i’ve been testing with d-c-fix mirror-effect privacy film and acrylic oneway mirror and both is interfering the PIR sensor so i had to put in a small box above the frame. Not a fancy design though…
For the acrylic i have spare place beneath the screen so i drilled a hole.
For the upcoming bath mirror i’ve ordered a Pilkington MirrorView. Don’t know yet if it will work with the sensor behind that glass though…otherwise i’ll put in a separate place/box. Hard to drill the glass and wouldn’t dare trying :-|

@sdetweil :rolling_on_the_floor_laughing:
Yes, i’ve built two mirrors and now working on my third bathroom mirror and with x number of files open in Notepad++ it’s getting messy…and even if you can see the file name and it’s location (host name) you end up editing elsewhere :dizzy_face:

@hedmik sorry, my bad, i was editing config in another pi…
Now it’s working now as it should :-)

More or less the same problem for me…
I’m using a velleman VMA314 connected to GPIO pin 11 (BCM GPIO 17) and module MMM-PIR-Sensor.
I’ve updated wiringPi for Pi 4 (wiringPi updated to 2.52 for the Raspberry Pi 4B)
I see that state changes using “gpio readall” but nothing happens…or to start with, connected screen does not even turn off after time set in config:

		{
			module: 'MMM-PIR-Sensor',
			config: {
			// See 'Configuration options' for more information.
				sensorPin: 17, // The pin (BCM numbering, NOT pin number itself) your PIR-sensor is connected to.
				powerSaving: true, // Should the monitor be turned off if no user is present? (via HDMI or relay)
				powerSavingDelay: 5, // Additional software side delay (in seconds) before the monitor will be turned off.
				powerSavingNotification: true, // To display a notification before to switch screen off
				powerSavingMessage: "Skärmen stängs av på grund av inaktivitet..." // Message notification to display before to switch screen off
				
			}
		},