@Stoffbeuteluwe yes its no problem with updating the globe modul…
Posts made by Meininger
Made in (east) Germany 😁
Now I want to introduce my Smart Mirror to you. Some time ago there was the idea of having a shelf in the bathroom next to the shower so that all the utensils were at hand. First the shelf should only have a little light, so cables were laid. During the construction phase, the plan came to integrate a Magic Mirror. The rest of the chestnut wood from the vanity was used for the cabinet. I also tried to bend solid wood to have a perfect grain. It went on with the hardware selection, in addition to the 21.5 inch display, an audio amplifier from justboom was also to be used. A Raspberry 3B controls the whole thing. Since I have successfully run multiroom audio components based on the Max2play image throughout the house, this was also the first step with the Magic mirror. So the thing with the music was cleared and plays perfectly. Then I wasn’t sure if it would be that easy with the Magic mirror, but to my absolute surprise, everything could be installed step by step as described in the online instructions. The whole thing starts when the room is entered. So I simply start the mirror’s power supply via Loxone, when I leave the room, the Raspberry is shut down cleanly and then the power supply is switched off with a time delay. How the whole thing looks, you can see in the pictures.
@idoodler so i have an idea how it not works for me. I dont use pm2 to start magicmirror. My mirror is in the badroom also for playing music, so i startet the setup with a max2play distribution for easy Audio Set up. Then i installed the magicmirror Script, its runs perfekt. Only starting the mirror with pm2 dosent work for me. So i looked for an other way to Start, i have found that with the crontap file, it starts the mirror at reboot.
At the Moment the mmm-Loxone Script runs ok for me, room Temperature, notifications and virtual Status values are publisched on the mirror. Thank you for this god Job!
My Loxone is on the acutal Software Version 10.0.9. 24.
i have the same problem with the presence option. when i enable the option the display switches off with the light controller in the room. wenn the light in the room is going on, the display is also going on, but only the cursor in the left top is blinking, no MagicMirror information is shown. Ich have updated the MMM-Loxone Modul und the MMM installation, the command in previus postings don´t bring back the screen…