@termeric said in Finsihed my first mirror: I added a back to the mirror and drilled some holes for ventilation, but i may either take it off or drill a few more since i’m getting the temperature indicator on the screen. Nice job. Looks great! IMHO, no need for a back at all. You can also drill ventilation holes in the the sides and the top and bottom. You will see a significant improvement in temp. And don’t rule out heatsinks or a fan. Both are inexpensive and you’ll never worry about heat again. When you see results like this you’ll sleep better. :-) [image: 1512958036071-1.png]

@termeric No that’s a monitor setting so what you have to do is some research because this isn’t the first time this has happened… look up your monitor and find out how to fix it :)

@termeric All better?

@termeric said in Starting MM on Reboot: Thanks, i needed to execute the command All is well. You’re welcome, mate. :-)

Yes you can use ANY material that you can make work. I would have preferred steel or alum but I have NO clue how to weld and paying someone would be VERY expensive…sooooooooooo I used the material I work with almost everyday…Wood. It’s inexpensive [depending on what you use] … I used mahogany alot… I have 3 built and they all have that in them…plus pine.

that looks like an ordinary mirror, so no. that would not work.

I’m trying to update using remote control and i get an error when i try. the update is actually for remote control, so i’m not sure if that is the problem. is there anything i should try to get this to work or do i need to do this the old fashioned way in the terminal?

I have recently installed this module and I love it. Suddenly ran into an issue where no modules load when looking at the edit view, shows no module loaded. What did I do wrong?