disable NO signal message

[bhepler]

Yes, but it’s not recommended. Those messages are there in case there is a problem during boot.

But if you really want it… Stack Exchange to the rescue. If that doesn’t do it for you, some quality time with Google and “Raspbery Pi silent boot” should get you there.

Edit: It seems that someone on YouTube has also done this.

[bibi]

@bhepler thx a lot for your reply/time :)

[strawberry 3.141]

@bibi the boot screen is replaced in the newest version if you are using the new raspbian version which is using PIXEL

[bibi]

@strawberry-3.141 i am not using it yet but will def. check that :) thx
can i have also your opinion regarding my 1st query pls?

[strawberry 3.141]

@bibi my monitor shows also no signal

[lolobyte]

@bibi

You cam manage boot options in raspi-config if you don’t have install jessi light.

execute following command.

sudo raspi-config

chose menu point

3 Boot Options
3B Splash Screen

and activate it wit “YES”

save and reboot with

sudo reboot
Next topic:
My screen show me a message with no signal for approx. 5 sec.
After that, the screen is complete black and off.

[bibi]

@lolobyte many thx for this how to! :))

[Deniz]

@broberg thx for the reply.
Are you satisfied with the monitor you are using?
Could you tell me the model number?

[lolobyte]

@Deniz

Hi, the screen i used, is a old monitor from a Lenovo G670 and one from a Pacard Bell PEW96

I use for each one a controller from eBay to to use them with the raspi.

HDMI+DVI+VGA+Audio LCD Controller Kit for 15.6" B156XW02 V.2 LED Panel 1366x768

HDMI+DVI+VGA+Audio Controller Board Driver Kit for LTN156AT05 LTN156AT02

[yawns]

@lolobyte
Are you happy with these 3rd party video controllers? I intend to buy one for my screen as well