Read the statement by Michael Teeuw here.
PIR-Sensor - put your mirror to sleep if not used
-
pm2 start mm -
@Bangee in that case read the wiki ;)
-
Funny…
pi@raspberrypi:~ $ tail -f /home/pi/.pm2/logs/mm-out-0.log GIPO Status:1 GIPO Status:0 GIPO Status:1 GIPO Status:0 GIPO Status:1 GIPO Status:0 GIPO Status:1 GIPO Status:0 GIPO Status:1 GIPO Status:0 -
@paviro The sensor I’ve got doesn’t have any adjustments on it. I suppose I can make little timed latch in hardware to add on, but it could be nice to do in software too.
-
@jrleeman feel free to send a pull request! :) the sensor I use cost 3€ do I don’t really see a reason to do it in software of the sensors are that cheap :smiley:
-
@paviro Fair enough. I’ll see which I find easier, code or hardware. :smiley:
-
@paviro
Thanks for making this module. I am experiencing the same issue as @incubik as my screen turns white when I start the MM. My PIR sensor works as I tested it on the R Pi and with some LEDs and my breadboard. I have reinstalled the MM and this module but I can’t seem to get it working. I have also no idea what causes this. Do you have any thought on this?
Thanks -
@sjuulbosmans white and black screens are mostly caused by wrong configuration. Check your web inspector!
-
I’ve tried to check the web inspector but when the screen is white… problems ahead —> The web inspector doesn’t pop up.
I’ve tried this without installing the PIR Sensor module and the web inspector works but again when the screen is in “white mode” doesn’t.
Any thoughts?
-
@incubik try the serveronly mode (see the wiki) :)
