"No Signal" message when PIR sensor is triggered

sdetweil

@steverichab don’t know the answer, but when u paste config or code, please use the code block,

after pasting the text, select it, and hit the </> button above the editor to wrap the text

sdetweil

@steverichab oh, and my TV does the same… the HDMI is turned off at the PI, so the tv shows no input

steverichab

Thanks Sam, As you can tell I’m a newbie but I really appreciate the coaching!

Is there a way to simple trigger a black screen saver via the PIRSensor module? really anything but a blue “No Signal” message.

Serge

@steverichab with mmm-remotecontrol you can “hide” all modules. So you will get a clear black screen without “no signal” message.

steverichab

@Serge said in "No Signal" message when PIR sensor is triggered:

mmm-remotecontrol

Thank You Serge, not sure how to hide when the PIR sensor module is triggered. I will start to work on it.

steverichab

@steverichab Wow Serg, My head exploded while trying to get the the MMM-Remote-Control module to “hide” just the calendar module when triggered by the MMM-PIRSensor module. Could you show or point me to an example of these two modules getting rid of this “no signal” problem.
Thanks!

lavolp3

@steverichab said in "No Signal" message when PIR sensor is triggered:

The MMM-PIRSensor is working perfectly. Unfortunately when the sensor times out due to no presents detected I get a blue screen with “No Signal” on my monitor/screen. Here’s my config:

 {
		module: 'MMM-PIR-Sensor', 
		position: "top_center", // Remove this line to avoid having an visible indicator
		config: {
			sensorPin: 22,
			powerSaving: true,
			powerSavingDelay: 10, // Turn HDMI OFF after 60 seconds of no motion, until motion is detected again
			preventHDMITimeout: 1, // Turn HDMI ON and OFF again every 4 minutes when power saving, to avoid LCD/TV timeout
			supportCEC: true, 
			presenceIndicator: "fa-eye", // Customizing the indicator
			presenceOffIndicator: "fa-eye", // Customizing the indicator
			presenceIndicatorColor: "#f51d16", // Customizing the indicator
			presenceOffIndicatorColor: "#2b271c" // Customizing the indicator
		}
		},

I have enabled HDMI CEC on my monitor. I just want it to go dark. any suggestions?
Thanks in advance!!

I have the same issue, and I am sure there was a time I got the monitor turned off directly with another module.
I think there are different ways of turning the monitor off, at least for more recent Raspberry Pis and this module might be using the wrong one for us.
I wanted to look into this more, you motivated me again :-).

steverichab

@lavolp3 Thanks, I hope you come up with something. As I said the frame is functioning perfectly except for the “no signal” problem. The MMM-Remote-Control module is tempting but I was not able to figure out how to “hide” everything when the PIR sensor triggered.

wishmaster270

@steverichab Hi, there are other PIR modules that support hiding out of the box like MMM-NewPIR or mine MMM-Screen-Powersave-Notification.
My module needs my GPIO module to get triggered. You ca find a complete example here

uros76

Are you on Pi 4 perhaps? I also got the same problem with the module mentioned above.
Then I switched to this one and it works https://github.com/bugsounet/MMM-NewPIR