Read the statement by Michael Teeuw here.
MMM-Jarvis-Voice-Control
-
Hello
Please reconfigure jarvis and change the hotword to something shorter. “Hello my friend!” is to long for your setup. Use something like “Ok Mirror”.
The circle will show up after jarvis recognises the hot word. After Jarvis recognised that you said that hotword.
Just like in the screen you shared it said that the hotword has to be between 0.5 and 1.5 speaking seconds.
After you reconfigure the hotword tell me if it works.
-
@merceaemil
I’ve changed hotword. But I cannot setup my microphone. I can configure either speakers or a microphone. it either asks to increase the signal or reduce during setup process.
When I say something during Setup Wizard for speaker it passed successfully but when it asks me to be silent it can’t finish and says decrease microphone gain. Please advise
Best, -
@aro28
I have builted microphone in my touch screen Monitor. Should I try another external USB microphone. -
i think you should try another mic. one that works on usb… or maybe use a webcam which has a builtin mic.
-
@merceaemil
Ok. Thank you! Will do tomorrow. -
@aro28
Hello,
Today i installed another mic thru the 3D sound card adapter and Setup Wizard has been completed successfully.
But MM is running without animated circle. Also, when i run Jarvis in troubleshooting mode, in the beginning it introduces itself and when i say something it’s just repeating my words
Should i configure something else? How do voice commands work here? I’m generally new to this.
Thank you in advance.
-
@aro28
Hi any updates on above?
What should to be installed first? MM or Jarvis?
Thanks! -
Clean it all out and reinstalled it…was good until Microsoft wanted a CC to register… that’s a big fat noooooooooooooooo…so this voice software will not do… ;)
-
@merceaemil
and to Anyone
How to Connect (Usage) Jarvis in Magic Mirror
such as How to open/close currentweather (Default module) ,
How to open/close clock (default module)
can you explain in detail becuase I,m Beginner
Thanks for your kind -
Hello,
although this thread is quite old, I have a question.
Is it possible to display the inner circle (e.g. in blue) when Jarvis is in standby mode?
