no just put " pm2 start.sh "

@cassidycaid yup is the same, i just show visual way, because is more simple for some ppl to understand.

I have been running teamviewer on my PI, and is works very well, i was afraid that TeamViewer would consume a lot of resources, but for what i see almost non, so until now is ok, the only problem i have is that TeamViewer will pop-up a window on every PI reboot, and the problem is that will appear over my MM.

I have try few solution by googling, to minimize teamviewer window, but non did work…

Any suggestion?

I usually do everything by SSH, but i would like to have this option enable just in case, i know i can use VNC, but i prefer teamviewer.

@Steff ty Steff, i did order today my PIR.

@Steff Sure Steff, post the Scheduler configuration.

Yes that is correct, you will always see the desktop for few seconds, then should open MM.
I think will happen the same with any other option you find to auto boot MM.

@broberg

The test i did with my LG monitor, was using remote module i did turn Monitor OFF, and my monitor will enter in standby after 2 sec, so i think that i can set the PIR to once detect movement will trigger the monitor to ON, and after X sec, if no movement is detect turn monitor OFF.

@yawns said in How do you turn Off/On the monitor if not in use - Be Green:

art. In

I agree, but the other problem i see with relay, is that you will be able to cut the energy, but once you order to power on, monitor will need human action to press power button :(

So after read so many post, i would like know how you turn Off/On your monitor when you are not using.

I can’t decide what is the best way to do this, after all i think we must be green and save some energy ;)

My idea is to active MM once someone get in front of the MM, then turn off the monitor to save some power, for this i think that PIR is the way to go, by power on/off the HDMI.
( was the solution i found on the forum that seems to work ok. )

Be free to tell how did you became green with your MM, i’m sure this is a topic that most of us are interested.

@cassidycaid yup is the same, i just show visual way, because is more simple for some ppl to understand.

Another happy person :D

no just put " pm2 start.sh "