UPDATE: Replaced my PIR-Sensor with a Doppler Microwave Sensor.

[cowboysdude]

@Mykle1 said in Replaced my PIR-Sensor with a Doppler Microwave Sensor.:

@Fozi

Excellent description. I like your innovation. I’m guessing this is going to replace the PIR sensor. I think most people have the same feeling as you about the appearance of the PIR. It does distract from the “magic”. Well done! :thumbsup:

That would be the idea…easier to ‘hide’… the PIR is nice but ugly.

[cowboysdude]

@Fozi said in Replaced my PIR-Sensor with a Doppler Microwave Sensor.:

RCWL-0516 microwave sensor

Thank you so much for this…ordering one so I can get rid of the ugly PIR in my bathroom!!!
Awesome job!!

[Fozi]

@cowboysdude Thanks! I’m looking forward to your experiences with the sensor!

[lavolp3]

@Fozi
I’ll try this out hopefully tonight but not with an Aluminium tape but with aluminum foil. Should work as well as far as I can see.

[Fozi]

@lavolp3 yes, should do equally. I had some leftover of the tape and it was more convenient to apply. I found some post from you a few months ago, when you struggled to make the sensor work. I hope you get some better results now.

[cowboysdude]

@Fozi Is there a wiring diagram for this? I know where the wires on my pi are and there two wires running to the sensor but where are they connected on the actual sensor?

Thanks!

[Fozi]

@cowboysdude
You only use Vin (5V), Vout and GND. CDS (for applying a photo diode) and 3V3 (delivers 3.3V output) remain unused. For Vout you can use also oher GPIO pins (labeled “Digital I/O” in the 2nd diagram), in case GPIO_4 is already used.

The ferrite bead is optional. It is a left over from the PIR sensor I had attached. If you may need one, you can dismantle an old VGA cable and use that one.
Here the wireing diagram:

[cowboysdude]

Super Awesome yet again!! Thank you! I don’t use the PIR module… I have a Python script I run behind everything. It works very well for me but this will work so nice, and now I can move it behind the glass!

Now if I can just remember where I put my ferrite beads… I know I have some … but where LOL

[Fozi]

Hi folks,

sooner than expected I modified the sensor with a trimmer resistor.
For that I also updated my initial post and enhanced the tutorial, where now both options are described. Enjoy and give me your feedback, how that works for you.

[sdetweil]

@Fozi nice update… very clear and helpful