Not that anyone would need to see this but I thought I’d share just for reference ( it’s blowing air out ).
I just cut a hole and glued the four corners of the fan down ( can take it out any time I wish ).
Honestly I think this thing def. needs a fan even with a heatsink. It gets way too hot. I have not finished with OS set up and config quite yet though so it’s not my focus yet, case wise. I had to open the top part of the case even though it was well ventilated, I added a fan and sinse then it’s been running cool to the touch where that was not the case with an open case and heatsink. I will def. encorporate a fan once I get to that point in my build.
embarrassed to even ask this but is there a step by step typed out of this other than what’s in the “README.dm” file, I mean some thing a little more detailed? noob status. apologies. I saw bminer1’s post but I’m looking for even more detail than that since I don’t know all the correct command lines. I have the .apk, just need help as my install failed.
Haven’t tried but If dropbox can run on Pi, all you need is this module?
Funk it… I was already troubleshooting cause I had already did it! LOL!!!
Now I have to look up how to remove them, I haven’t done linux in 10 years.
That’s what happens when you get too excited and don’t pay attention. DOH.