@Kimzer Try this: https://forum.magicmirror.builders/topic/490/motion-detector

@trekky Thanks

@trekky So… how do you send the notification?

@techadi Looks awesome!! Congrats!

@FreddyH Thanks!
Kind regards

Hi! This should be one of the best mirrors you have seen so far. Very impressive!!
I am developing mine, I am close to finishing it, but I am very stuck with the integration with alexa.
I would be very grateful if you could tell me how you did yours, some step by step or tip to take into account.

Kind regards

Hi @paviro !
Great module.
I was wondering if it is possible to add the bullet simbol to each task.
Kind regards

@dolanmiu Hi @dolanmiu hope you’re finding very well!
could you fix the helper website?
Kind regards

@McSorley Hi I have tested, and always says motion detected, never ends, even when there is no motion

@McSorley so, the (4) you’ve put in the example before, wich of the 3 cables is?
Sorry, I’m pretty new in this, and I can’t get it easyly

@McSorley said in PIR Sensor + Raspi:

Keeping in mind for both this code and the module that you have the correct pin number.

How do I know in what pin are the 3 cables connected?

@PtrBld Hi! I am trying yo use the PIR-Sensor module, but I have no result, the screen never goes black.
I have connected the cables as the picture you post. Any idea why is not working?

@PtrBld Thank you very much!

Hi everyone!
I’ve got a doubt. I’ve been watching a few videos on youtube on how to connect the pir sensor to the raspi.
In every video, they use an arduino or a protoboard. Is this really necesary, or with the female-female cable, the PIR sensor and the raspi is enought?

Kind regards

Do I need anything else than the raspi, cable and pir sensor?
An arduino for example?

Kind regards

@yawns great, and can I copy the folder, so I have the original module with it’s original name, and the copy with the custom name?

@danielis Hi! I’ve tried, but still can’t get it. So I was thinking, instead of putting of the monitor, is it possible to show a black image for example?
So when it detects movement, the MM appears, and when not, a black photo is shown.
Is it possible?

Hi everyone! I hope you’re finding very well!

I have a doubt… is it possible to change the modules original name? For example change iFrame for News1

Kind regards

Hi @joanaz !
The module looks great! Thanks for developing it.
Could you help me with this?
I’m stuck over this step:

Can’t find the way to install the dependencies.