MagicMirror does not work at startup

[mpires]

no just put " pm2 start.sh "

[mpires]

Another happy person :D

[cassidycaid]

Thanks for the information. Using it I was able to figure out the steps for the command line.

cd ~/.config/lxsession/LXDE-pi
sudo nano autostart

add to the end

pm2 start mm.sh

Thanks again for helping.

[mpires]

@cassidycaid yup is the same, i just show visual way, because is more simple for some ppl to understand.

[amomat]

@cassidycaid Worked like a charm. Thanks a bunch.

[TheSt33v]

When I boot the pi, I see the MagicMirror boot screen, the desktop, and then MagicMirror boots. Following the steps above did not solve the problem. Is the desktop supposed to show up before MagicMirror boots, or is it supposed to go straight into MagicMirror? After I see the boot screen and right before I see the desktop, it briefly becomes a black screen with an X in the upper left corner of the screen. Any ideas on what might be wrong? I have pm2 installed and it is functioning perfectly.

[mpires]

Yes that is correct, you will always see the desktop for few seconds, then should open MM.
I think will happen the same with any other option you find to auto boot MM.