MMM-PIR or MMM-PIR-Sensor issues...

[cowboysdude]

@onis_uk what’s funny is that I cannot get it work any longer… since Buster came out and I upgraded it turns off but not back on…LOL

[sdetweil]

@cowboysdude someone had to add a parm to the command

Either way, i found another way which is using the command 'vcgencmd display_power 0 2' and
'vcgencmd display_power 1 2' 
where the 0 stands for Off and 1 stands for On and the 2 stands for my display ID. 

[cowboysdude]

@sdetweil Thank you!! Been looking all day… gonna try this right now!

[cowboysdude]

@sdetweil My old Pir Sensor does not work at all on Buster.

[sdetweil]

@cowboysdude eh?

[sdetweil]

@sdetweil if u ssh in do the two commands work?

[cowboysdude]

IN case anyone is still looking for a way to do this since they updated the PI4 it’s easier:

You can use 1 of 2 methods here:

https://github.com/cowboysdude/Pir-Sensor

or [even better solution IMO]

https://github.com/bugsounet/MMM-NewPIR

[bugsounet]

@cowboysdude

• Thanks to don’t to advertise any of my modules on this forum
• Thanks to not offer any support of my modules on this forum

I repeat again (again, again ?):

• I am not a reference in this forum
• I’m a VERY BAD guys in this forum
• That’s why any of my modules is not on the 3rd party modules

[sdetweil]

@bugsounet said in MMM-PIR or MMM-PIR-Sensor issues...:

I am not a reference in this forum

only because you choose it to be that way.

[bugsounet]

@sdetweil sure and i assume it :)
[and i will continue… on this way there]