Read the statement by Michael Teeuw here.
PIR sensor problem after restart Raspi
-
Hello,
i restarted my Raspi yesterday, since then the monitor hasn’t gone into standby anymore. I think some Raspian updates have been installed, could it be related to that? Nothing was changed in the MM configuration. Does somebody has any idea?Greetings Joerg
-
@JoeFranz have you checked the logs and see whats throwing errors? That is where I would start.
-
@kayakbabe There are no errors in the logs, nothing was changed in MM. Otherwise the screen was always black when MM started, and the monitor only came on after there was movement in front of the PIR sensor. Now the picture is there right after the start and the monitor no longer goes into standby. So I think it must be something to do with Raspian. Or maybe Electron? I have no idea what happened there… :-(
-
@JoeFranz which pir module are you using?
-
@sdetweil MMM-PIR-Sensor
-
@JoeFranz I can recommend these two modules for the PIR (I just installed them, they also work with the S.O. bullseye):
MMM-GPIO-Notifications: https://github.com/Tom-Hirschberger/MMM-GPIO-Notifications
MMM-Screen-Powersave-Notification: https://github.com/Tom-Hirschberger/MMM-Screen-Powersave-Notification -
@Egnos Doesn’t work either, the monitor doesn’t go into standby :-( The Raspbian screensaver function does not seem to work. Can this be reinstalled?
-
@JoeFranz have you tried to run the two modules following this guide written by @wishmaster270 ?
https://github.com/Tom-Hirschberger/MMM-GPIO-Notifications/blob/master/examples/HC-SR501/HC-SR501-GPIO4-README-EN.mdWhich PIR sensor do you have?
-
@Egnos I did it according to this guide (in German) have the same pir sensor as in the guide.
-
@JoeFranz said in PIR sensor problem after restart Raspi:
I did it according to this guide (in German) have the same pir sensor as in the guide.
Have you checked that the PIR is on the correct pins of the GPIO?
