Internet Monitor

[ronny3050]

@Mykle1 Could you run the following?
pm2 flush
pm2 logs and wait for a couple of minutes of log?

Thanks!

[Mykle1]

@ronny3050 wait for it to complete doing something? Will it stop by itself or I have to do something?

If so, what do I have to do?

It’s running now

[ronny3050]

@Mykle1 yes, after typing pm2 logs it will update logs realtime so then you can post it here. I am wondering what exactly crashes your mirror inside my module.

[Mykle1]

@ronny3050 ok, I’m waiting for it to complete

[Mykle1]

I’ve been waiting for 34 minutes and nothing has happened. My console still reads:

[STREAMING] Now streaming realtime logs for [all] processes.

Am I supposed to do something? run MM with your module perhaps? You didn’t say

[Mykle1]

Well, I waited over and hour, staring at the console, and nothing happened since I ran:
pm2 flush
pm2 logs

Here is what I’ve been staring at:

pi@Pi3:~ $ pm2 flush
[PM2] Flushing /home/pi/.pm2/pm2.log
[PM2] Flushing
[PM2] /home/pi/.pm2/logs/mm-out-0.log
[PM2] /home/pi/.pm2/logs/mm-error-0.log
[PM2] Logs flushed
pi@Pi3:~ $ pm2 logs
[TAILING] Tailing last 10 lines for [all] processes (change the value with --lines option)
/home/pi/.pm2/pm2.log last 10 lines:
/home/pi/.pm2/logs/mm-out-0.log last 10 lines:
/home/pi/.pm2/logs/mm-error-0.log last 10 lines:
[STREAMING] Now streaming realtime logs for [all] processes

[Mykle1]

@cowboysdude said in Internet Monitor:

I tell you what I’d do before I tried it again… backup my sd card

Done. I made two backups of my SD card. One locally and one on my backup server. While that was going on I installed a fan on my Pi. I have spare parts lying around. Good little mini project while I waited for the backups. Now my Pi runs at 35 C, down from 60 C. Sweet.

[cowboysdude]

@Mykle1 That’s a great idea that I should probably do as well… adding the fan!!!

[pjkoeleman]

@Mykle1 said in Internet Monitor:
@ronny3050 thanks for a nice Monitor, i love the wifi indicator.

You asked for wishes for the Internet Monitor.
I have been looking in the code if it is possible to give te wifi indicators some color.
Making strength_full.png green, strength_almost yellow, strength_half orange and strength_non.png red. Would love to see this as an config option of in the my custom.css.

Is there a way to do this?

[Advokaten]

@pjkoeleman is this module working for you? I can’t get it to work :(