Downgrade Magic Mirror?

Mykle1

Rename your current MagicMirror folder to something else.
Install the MM version of your choice.
Move your modules into the new MagicMirror folder.

cowboysdude

Stick of dynamite… hahahaahhha

chaseb1357

@cowboysdude Thank you so much, it worked like a charm. After successfully welding an enclosure together to put the dynamite and RPi, I set it off. And BOOM! Magic Mirror is now running like a charm ;)

MichMich

Just curious. Why do you want to downgrade?

chaseb1357

@MichMich The only reason for me is I really love the ability to use the Remote Control module so I can easily remote access my mirrors. And I noticed in the new update that Http isn’t working, so I just want to go back to where I can remote access my mirrors.

cruunnerr

strange… i use the actual version and remote control is working. i even updated the mirror with the remote control module XD worked fine :)

chaseb1357

@cruunnerr that is strange indeed. I’m not sure what’s going on with my setup then. I mainly made this post because I discovered this one researching before posting: https://forum.magicmirror.builders/topic/5025/can-t-access-magic-mirror-via-http

cruunnerr

well, i allowed to listen to all ip’s at all:

var config = {
        address: "0.0.0.0", // Address to listen on, can be:
                              // - "localhost", "127.0.0.1", "::1" to listen on lo$
                              // - another specific IPv4/6 to listen on a specific$
                              // - "", "0.0.0.0", "::" to listen on any interface
                              // Default, when address config is left out, is "loc$
        port: 8080,
        ipWhitelist: [], // Set [] to allow all IP addresses
                                                               // or add a specifi$
                                                               // ["127.0.0.1", ":$
                                                               // or IPv4 range of$
                                                               // ["127.0.0.1", ":$

Maybe thats the reason. I had a few problems with just allowing single ip dresses so i went to this option. But works fine, and i have a hardware firewall installed in my network so i hope that this is enough^^

for external access i use VPN

chaseb1357

Well what do you know. It works now! My old code was this and it worked fine on older versions:

	"ipWhitelist": [
		"127.0.0.1",
		"::ffff:127.0.0.1",
		"::1",
		"192.168.11.1/24",
		"::ffff:192.168.11.1/24" 
	]

But now that I put this it works fine, no need to downgrade now, much thanks:

	"address": "0.0.0.0",
	"ipWhitelist": [
	]

cruunnerr

great :)

first i tried it with “192.168.178.0/24”, too but couldn’t get it work. i read something about disabling IPv6 would help etc.

but however i am glad u got it working