Stop the screensaver!

Chris

Hello,

After a total reinstall of the recent raspberry to integrate Google Assist Pi, I also have the same problem.

After watching, I end up with an empty screen after about 6 hours. I am forced to restart MagicMirror via the MMM-Remote-Control module.
On the other hand I do not have xsceensaver of installed but the modification of the lines of command indicated in the wiki of installation of MM

I did not experience this problem before. The only difference between my two installations is the 2.3.1 update of MagicMirror.
Would it affect?

Regards,

Gabev

I had the same problem where. I stumbled across this thread, check out the answer given by JimmyN… it helped me at least.

m0111k

@cowboysdude tried that, screen still went standby… any clue for fix?
ps im newb here, how can i remove xscreensaver when it doesnt work? Thanks

Mykle1

@m0111k said in Stop the screensaver!:

ps im newb here, how can i remove xscreensaver when it doesnt work? Thanks

sudo apt-get remove xscreensaver

However, I don’t think xscreensaver is capable of putting your display into standby. That is likely your system or settings.

Anthony

@Mykle1
Is there any possibillity that Lucy interacts somehow with the screen saver? I am asking this because I have installed xscreensaver and working good but if I have lucy enabled I get the black screen and I must move the mouse to sho the MM again. Just a thought!

Mykle1

@Anthony

Perhaps, but I’ve never seen this behavior or heard about it before this. I will see if I can reproduce that here.

Mykle1

@Anthony

I’m not seeing this behavior at all. You can clearly see that I have xscreensaver running with the “Screen Saver DIsabled” but I can’t reproduce what it happening to you. Lucy responds normally and no black screen issue. If you say “SHOW MODULES” does Lucy show them?

![0_1551838003790_Screenshot.png](Uploading 100%)

Edit: Something seems to be amiss. The forum isn’t allowing me to post an image at the moment.

Picture below.

Mykle1

Anthony

@Mykle1
Thank you for your reply. I haven’t try to see if Lucy works when I see the black screen because I can’t see the “Say, ‘Hello Lucy’” message and because of the latency problems I have I don’t know when it recognizes the keyword and wait for commands. My guess is that it will work but when I am finished with my mirrorsetup I will hung it on the wall so I won’t have mouse and keyboard connected to move or press a button for the mirror to show. Also the black screen appears not only in the standby mode. Last night I left the mirror showing my page 1 modules and in the morning I saw the black screen again. Moved the mouse and evertything showed up.

sdetweil

@Anthony said in Stop the screensaver!:

Moved the mouse and evertything showed up.

that means screensaver kicked in… MM doesn’t do module visibility by mouse movement…