@ryck
Thank you for your help! :)
Finally it works now.

By the way… the module looks pretty cool ;-)

Dear @jchan,
the mirror is attached through 4 screws which I drilled through the glas. (make sure that you tape before drilling otherwise the glas will break).

The wood is just plain wood from the local shop.

Dear @ryck,

I have installed your module and it works up to the point, where it shows me that “no data is returned”.

I guess that my wiring is wrong.
What do you think?

@cruunnerr thank you for your fast reply.
I ve tried to run it but unfortunately the console tells me to commit changes or to stash them before I can merge.

Unfortunately I have no clue what this means. Could you help me out? :)

Dear fellows,

I would like to know how to update the MagicMirror 2 setup. My current problem is following:

the software tells me that I am 251 commits behind the master branch.

Unfortunately updating everyhting did not work.
I updated it via following command:
“sudo apt-get update && apt-get upgrade”

Does someone has the same probem?
Many greetings from Hamburg :)

Dear @iwaldrum ,
this is such a cool set-up. Well done! :)

Hey guys :) Hope you are all good.
Finally I have the time to work on this module again :)
I had the same errors like you before and unsuprisingly did not found a solution for it.

Is someone in this thread still active?

@georg90

I am about to install it on my setup. Unfortunately due to the old link its not possible. Although you can ask HVV for a Geofox-API I am not quite sure, if it is the smoothest solution.

What do you think?

@ryck

I delete everything and set it up from scratch again.
Unfortunately, as I start the MMM application your module is not shown on the screen. Do you have an idea where the problem is located?

I used your config.js-example and just changed the Pinnumber from 2 to 4.

Kind regards,
Paul

@ryck

Thanks for your quick reply :
I have checked the config file as well as the set up. Checking the sensor via the console works fine.

My next steps are deleting the module and downloading it again. Following step by step your manual.

I keep you updated :)