No sound from my RPi 3 B.

[BillW]

I should have included in my first post, but I did attach a separate cable for sound to speakers, but that didn’t work so I tried earphones to make sure. Thanks for confirming that for me. Any other suggestions?

[sdetweil]

@BillW did the earphones work?

[sdetweil]

@sdetweil do system sounds work?

[BillW]

@sdetweil No

[sdetweil]

https://www.raspberrypi.org/documentation/configuration/audio-config.md

Sound is going out the HDMI cable

[BillW]

I’ll follow the link and check it out, then I’ll let you know what I did. Thanks for the guidance.

[sdetweil]

@BillW this one too

https://www.cb-net.co.uk/linux/getting-analogue-sound-working-raspberry-pi-3b-raspbian-stretch/

[BillW]

Ok, tried all three but no luck, not sure what to do next. Here’s a copy of my config file if that may help

For more options and information see

http://rpf.io/configtxt

Some settings may impact device functionality. See link above for details

uncomment if you get no picture on HDMI for a default “safe” mode

#hdmi_safe=1

uncomment this if your display has a black border of unused pixels visible

and your display can output without overscan

#disable_overscan=1

uncomment the following to adjust overscan. Use positive numbers if console

goes off screen, and negative if there is too much border

#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

uncomment to force a console size. By default it will be display’s size minus

overscan.

#framebuffer_width=1280
#framebuffer_height=720

uncomment if hdmi display is not detected and composite is being output

#hdmi_force_hotplug=1

uncomment to force a specific HDMI mode (this will force VGA)

#hdmi_group=1
#hdmi_mode=1

uncomment to force a HDMI mode rather than DVI. This can make audio work in

DMT (computer monitor) modes

#hdmi_drive=2

uncomment to increase signal to HDMI, if you have interference, blanking, or

no display

#config_hdmi_boost=4

uncomment for composite PAL

#sdtv_mode=2

#uncomment to overclock the arm. 700 MHz is the default.
#arm_freq=800

Uncomment some or all of these to enable the optional hardware interfaces

#dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on

Uncomment this to enable the lirc-rpi module

#dtoverlay=lirc-rpi

Additional overlays and parameters are documented /boot/overlays/README

Enable audio (loads snd_bcm2835)

#dtparam=audio=on
[pi0]
dtoverlay=dwc2
[all]
start_x=1
gpu_mem=128
dtoverlay=googlevoicehat-soundcard
display_rotate=1

Sorry for the large font, not well verse with the editing portion of this forum.

[sdetweil]

@BillW use the markdown 3 backticks before and after… key to the left of number 1

you can edit it… pound sign makes large font

my device doesn’t have an analog audio port

[BillW]

My knowledge of this is very limited, I don’t understand where you want me to put the markdown at?