The tutorial found here can help you with what to type to get your config correct.

I use the HDMI interface display

I did it for you :) But you can also find it here:
0_1467408732370_solved.png

Yes, thank You very much :) it is working…

But calendar module and rss feed module is loading and loading, config file is ok because “server only” is fine, any ideas ?

Ok, with other url it’s OK.
Thanks

@Bangee

Perfect ! I installed MM2 as PI user and it works now !

Thanks for your help

Typing in 'pm2 logs' will display those specific logs in a nicely formatted display.

@ellercom, when you tied the default config, did you actually restart the MM process completely? You said you’re running it as a serveronly, so have you killed the process and restarted it? Does the default config also jst display ‘Loading…’?

i’m also waiting for the PIR sensors hoping it will work out of the box with the module created by @paviro otherwise i Have to start debugging.

@Wilco89 Raspberry Pi 3, 5V 2.5A Should be more than sufficient. It doesn’t show the square with colors, what normally would show when power is to low.

@firesgc

I had the same problem as you, and after trying almost everything I found where was the problem.

To add your user PI to GPIO group, in the module page says to run:
sudo useradd -g pi gpio
My RPI always replay me that GPIO group already exists… so nothing happend

I solve it by running:
sudo usermod -a -G gpio pi
In this case pi user is added to gpio group

I just restarted and it worked.

Now using the following command:
gpio readall
I can see how the Inputs and Outputs change

I hope it works also for you

Are you sure, that the files are there?
If the are, let’s try to restart pm2 restart mm or sudo reboot.

@flooo sudo apt-get install x11-xserver-utils worked x11-xserver-utils is installed fine with no errors.

Glad that’s working. It still doesn’t solve the fact that it’s dying on you, but at least it will restart it automatically for you. I think my process dies at least once a week or so … totally random, with the pi doing nothing.

@KirAsh4
Thanks for the reply, I used the same command to install mm2 as per your detailed tutorial. Though some commands after installed mm2 were different so shall retry the whole thing.

Thanks,
Mihir

I have had my MM running for about 2 months now and everything was working fine till about 10 days ago. The Current Conditions stopped updating. If I reboot or open the site in my desktop browser the weather conditions will populate correctly with the current conditions but not update. i have look to see if the network is dropping the connection and it is not. Any thoughts?

@chenz0 I am having the same issue with the compliments and newsfeed not going to the bottom, I am also running this on a B+. Could you explain in a little more detail what you changed? Changing calc(100%-120px) to 100% just makes everything go off the right of the screen (and those are the only uses of the calc function I could find in main.css). I am very new to CSS.

@acdacd2 good job!

@strawberry-3-141 Try timeFormat: 12, instead of timeformat: 12,.

Capitalization has gotten me more times that I can count.

Hi KirAsh4,

OK Thanks.
I’ll test directly on a raspberry and not on a VM.

Thanks, but I’ll wait till my US vendor has them. $5 plus free shipping beats getting it from the UK.