I finally managed to get the module running. I used the following fork
https://github.com/magicmirror-sdmy/MMM-PlaceInfo
Thanks once again for the help from you both
I finally managed to get the module running. I used the following fork
https://github.com/magicmirror-sdmy/MMM-PlaceInfo
Thanks once again for the help from you both
@lmhmm
@sdetweil
Thanks all. I am much closer than before. I now at least have a visual of the module. I however currently see on the mirror the following just below the Flag, City, Time.
Currency failed (401)
Weather failed (HTTP 400)
I think it might be that i am blocked being in South Africa but i will still try a few things
Thanks so much for the advise and help, its much appreciated
@sdetweil
Thanks very much for the heads up. I remember now when one of my displays crashed due to the 2.5 that had to be changed to 3.0. Thanks for the quick response
@Dresch360
I suspect it is a “,” issue but I also cant seem to figure it. Did you manage?
@mumblebaj
I am going to try that with my previous image. Thanks for the heads up
@mumblebaj
Awesome, thanks very much for the quick response and assistance. I have a visual and cant wait for load-shedding to start again to see the module in action lol :-) :-)
My mirror is a very old build and I had to install MagicMirror from scratch but it was only a question of time before I had to do that
Thanks for the great app that you made available. It really gives the mirror so much more purpose
@mumblebaj
Hi guys
I please need your help. When I make use of the api, do I leave it exactly as is or do I remove the “-” in-between the characters
Is this fine
token: "1234ABCD-5678EFGH-1234ABCD-5678EFGH ",
I am also unsure about the area. I have run the below in the command prompt on the Pi but I don’t get the correct info
curl --location --request GET “https://developer.sepush.co.za/business/2.0/area?id=eskde-10-fourwaysext10cityofjohannesburggauteng” \ –header "1234ABCD-5678EFGH-1234ABCD-5678EFGH "
Currently my area on the phone app indicate as below
Golden Harvest A.H (10)
Golden Harvest A.H (5)|JHB City Power
Please advise me on the correct way to get the area
@mz-ber
The controller board with the low pass filter
@mz-ber
Apologies for the late response
1, 2 and 3 is capacitors yes
4 & 5 is inductors or coils. The rule is a Capacitor conduct high frequency but block low frequency. The coil or inductor is doing the opposite, and conduct low frequency but block high frequency. The whole idea is to short circuit any spikes on the power line as well as the data line to ground. This is quite a big low pass filter and you can make it smaller with less components.
Remove 1
Leave 4 & 2
Replace 5 with a wire
6 is a resister yes. 10 Kilo Ohm 1/4 watt is perfect
The coils you can strip out of an old circuit board. If it looks like a wire wind coil and it measure less than 3 ohm then its perfect